The code example uses only one interrupt i.e. BLESS interrupt. Are you mentioning about the following documentation? I am not able to find information about 3 interrupt sources. Kindly point me to the document you have gone through.
If you want to add other interrupts to the existing project, you can refer Interrupt code examples CE220169, CE219521.
You can also look at MCWDT interrupts and dedicated code example interrupt from the PSoC Creator code examples section.
if you go to the page 3 under the section Switching the CPU Cores Usage, you can find the following statement:
"The BLE Subsystem (BLESS) interrupt must be assigned to the core where the controller runs. All additional interrupts (SW2, MCWDT, etc.) used in the example must be assigned to the host core".
Also in the Figure 3 from the documente the third figure shows 3 interrupts in the DWR section.
When I downloaded the example file, in the Interrupts section was only the BLE_bless_irs. How can I add the others two?
1 of 1 people found this helpful
I got it. Thank you for pointing this out to us. Please give me one day to get back to you with corrections.
Thanks and regards
Please find the attached project developed for CY8CKIT-062. The project contains BLE component configured with Battery level service.
Also it has a Timer to process BLE interrupts on every 10ms interval. A battery level simulator Timer to change the battery level, a pin interrupt to send the battery level information on every button press. Please check it once.
CY8CKIT-062.cywrk.Archive01.zip 16.8 MB