3 Replies Latest reply on Aug 15, 2019 2:31 AM by TaCh_734676

    CYBLE416045 module unable to debug

    TaCh_734676

      Good day,

       

      I have developed a board using the CYBLE416045-2.

      I have also a CY8CPROTO-063-BLE prototyping board with CYBLE416045-2.

      On PSoC 4.2, I created a project based on the BLE Find Me example code.

       

      On the CY8CPROTO-063-BLE board. I was able to program it to run in Debug mode and the code is able to break at the start of the main function for CM4.

      However, with the same project, there is an issue that the customized board is not able to run in the Debug mode.

       

      The following message was shown in the Output window.

      *************************

      Programming device 'PSoC 63 CYBLE-416045-02 (CM4)' with file 'C:\Users\CTWMac\Documents\PSoC Creator\BLE01\BLE01.cydsn\CortexM4\ARM_GCC_541\Debug\BLE01.hex'.

      Device ID Check

      Erasing of Main Flash...

      Programming of Flash Starting...

      Protecting...

      Verify Checksum...

      Finished Programming

      Device 'PSoC 63 CYBLE-416045-02 (CM4)' was successfully programmed at 08/15/2019 15:18:10.

      Continuing target program

      The target program has stopped at: file:  line: -1 function: ?? address: 0x1600400C

      ***********************

      PSoc_Debug_Error.png

       

      The schematic layout for the BLE portion of the customized is

      BLE_Schematic.png

      Can anyone please advice the possible issue that I may have?

       

      Thank you.