- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello
cyw43340 Tx power can be adjusted,I have the following questions:
Refer to otp document:
maxp2ga0=0x46,max output power is 17.5dbm,the nominal power is 17.5 – 1.0 = 16.5 dBm.
What is the actual power output if the following configuration is used:
maxp2ga0=0x46
ofdm2gpo=0x44444444(back-off power is 2dbm)
when rate is 6Mbps,The actual output power should choose which of the following?
1.max output power(17.5)-2dbm =15.5 dbm
2.the nominal power(16.5) - 2 dbm = 14.5 dbm
think you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sure, actually , RF power doesn't show a very stable value when doing TX . You can get the results by watch the test device, it always shows a max power and average power ...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
from the nvram setting, it is 17.5 -2 =15.5 dbm.
Where do you get the nominal power value with 1 dbm backoff ?
and what is the actual test result ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello:
Where do you get the nominal power value with 1 dbm backoff ?
on 43340 OTP document,as following:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sure, actually , RF power doesn't show a very stable value when doing TX . You can get the results by watch the test device, it always shows a max power and average power ...