Jul 24, 2019
10:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 24, 2019
10:51 PM
S29GL064S NOR Flash Pins 1 ,2 & 56 are NC as per datasheet. I'm using this as a replacement part...Would the device response would change if toggling signal is applied to this three NC pins? I need this information for debugging purpose.
Solved! Go to Solution.
Labels
- Labels:
-
Parallel NOR
1 Solution
Jul 25, 2019
12:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 25, 2019
12:39 AM
Hi Venkatesh,
Thank you for contacting Cypress.
Since NC pins do not have any internal connections, the response should not get varied if you are applying any signal to the pins.
Regards,
Apurva
1 Reply
Jul 25, 2019
12:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 25, 2019
12:39 AM
Hi Venkatesh,
Thank you for contacting Cypress.
Since NC pins do not have any internal connections, the response should not get varied if you are applying any signal to the pins.
Regards,
Apurva