3 Replies Latest reply on Jul 18, 2019 2:29 PM by BushraH_91

    Curious about differences between  S26KL512S vs S26HL512S

    RoYo_979511

      The S26KL is a HyperBus product family, the S26HL512S is Semper HyperBus family.  Curious about the differences between these.

      The data sheet for S26KL512S seems much better (clearer etc) than S26HL512S datasheet.  Specifically with respect to Hyper Bus transaction timing diagrams.

      And details on Read/Write Latency.  I'm digging through the documentation for Semper and just trying to understand evolution of the product and documentation.

        • 1. Re: Curious about differences between  S26KL512S vs S26HL512S
          BushraH_91

          Hello Ross,

          Can you please verify if S26HL512S is correct MPN? Did you join our Semper access program (https://www.cypress.com/semper-eap-form) to get the latest Semper documents?

           

          Thank you

          Regards,

          Bushra

          • 2. Re: Curious about differences between  S26KL512S vs S26HL512S
            RoYo_979511

            Yes I have joined the access program.

            I was just taking the MPN off the top of the documents:

            Sooo if the numbers on the top of the document are not "MPN" (Manufacturer Part Numbers)... then whatever those numbers are... the two documents do a significantly different quality job of discussing HYPER BUS transactions with respect to the DUTS.  I only had the Preliminary document and was fighting to understand Table 128 in the SEMPER doc.  The apparently older more mature docs were helpful.  Was just trying to understand differences.  Turns out the older part is slower speed ~333Mbit and Semper is ~400Mbit, there may be other significant differences.

             

            Document Number: 001-99198 Rev. *M  -- Good discussion of Hyper Bus transactions etc

             

            Document Number 002-12337 Rev N.

            • 3. Re: Curious about differences between  S26KL512S vs S26HL512S
              BushraH_91

              Hello Ross,

              Please refer to Semper Access Program Community for AN223680 which provides guidelines for migration from Cypress’ 65-nm KL/S-S HyperFlash™ product family to Cypress’ 45-nm HL/S-T Semper™ Flash product family. It describes the similarities and the differences to facilitate a seamless conversion.

               

              MPN and speed grade definition can be found under Ordering Information section of particular datasheet.

               

              Thank you and have a nice day

              Regards,

              Bushra

              1 of 1 people found this helpful