4 Replies Latest reply on Jul 15, 2019 12:45 PM by maku_3939256

    Required Commands for ETIS certification for BCM43455 Module

    maku_3939256

      Hi,

       

      We require your help for below commands to run for our Module certification.

       

      WiFi:

      • Packet Error Rate Calculation in Rx Blocking Mode Test

       

      BT:

      • Change Data Pattern: Require to send customized data pattern.
      • Bit Rate Error Calculation for Rx Blocking Mode Test
      • Modifying BT Tx Power: Commands to SET/GET Tx Power

       

      BLE:

      • Default Tx Power: Commands to SET/GET Tx Power

       

      Here are the software version details:

      WiFi Driver Version:

      Loading modules backported from Linux version v4.14.52-manda-RTM-0-g897c6ce

      Backport generated by backports.git v4.14-rc2-1-70-g694b78f

      brcmfmac: brcmf_fw_map_chip_to_name: using brcm/brcmfmac43455-sdio.bin for chip 0x004345(17221) rev 0x000006

      usbcore: registered new interface driver brcmfmac

      brcmfmac: brcmf_c_preinit_dcmds: Murata Customized Version: imx-rocko-manda_r1.0;

      brcmfmac: brcmf_c_preinit_dcmds: Firmware version = wl0: Sep 21 2018 04:08:34 version 7.45.173 (r707987 CY) FWID 01-d2799ea2

       

      Wl Version:

      1.21 RC0.0

      wl0: Sep 21 2018 04:08:34 version 7.45.173 (r707987 CY) FWID 01-d2799ea2

       

      Bluetooth Stack:

      bluez5.46

       

      Let us know if any more details are required.