2 Replies Latest reply on Jul 19, 2019 1:53 AM by SadaharuK_26

    S6BT112A Power-on Sequence NSLP permanently High

    acsi_4349416

      Hello,

      I'm working on a S6BT112A design without a MCU and can therefore not simply delay the rise of NSLP on Power-On.

      Would it be a valid design to connect NSLP permanently to +5V?

      Would this put the S6BT112A into Normal Mode after Power On?

       

      +5V would be available sooner to the circuit than V_Bat, could this be an issue if the NSLP & SELMS Pins are driven high before the Bat Pin is powered?

       

      Here is a quick illustration of my intended circuit.

       

      rect3280.png

      Best Regards

      Achim