3 Replies Latest reply on Jul 15, 2019 3:34 AM by ShifangZ_26

    CYPD3125 Firmware programming

    PoVe_3939176

      Hi @LisaZ_26

       

      This thread is regarding CYPD3125 Hardware Configuration. Still am facing same problem can't able to reply for previous thread and can't able to create even discussion.

       

      As per your suggestion, used Miniprog3 for programming via SWD interface and programming also succeed.

      But Across VBUS getting milli volts only and even mosfet's are also not enabled, across VBUS_P_CTRL0/1 getting milli volts.

      The MOSFET's are N-Type MOSFET. Attached schematics for your reference

       

      Programmed CYPD3125-40LQXI_notebook firmware. Kindly advise to overcome this problem.

       

      Regards

      Srini