- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi:
I use the light dimmable project to develop the bluetooth mesh, I find the wiced_bt_mesh_light_lightness_nvram_id_start in the mesh_setup_nvram_ids(),
I want to know which prameters the nv id have saved .
so I use the wiced_hal_read_nvram API to read the value from the nv id. it seems irregular value。
I want to know if there are some documents to introduce which parameters of the model have been saved into the nvram
thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The information for the model state are defined in the model spec: https://www.bluetooth.com/specifications/mesh-specifications/
The NVRAM information are defined in the lower level of the SDK and not open to the customer. May I know why you need these information?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The wiced_bt_mesh_light_lightness_nvram_id_start saves the configuration and states for the model. It is used for the low layer stack which is in the lib file and is not open to the customer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi OWenZ_26:
I want to know which configuration and states are saved and the detail locations in the nv !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The information for the model state are defined in the model spec: https://www.bluetooth.com/specifications/mesh-specifications/
The NVRAM information are defined in the lower level of the SDK and not open to the customer. May I know why you need these information?