- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have recently acquired the new Cypress Microprocessor; the CY8KIT-148 PSOC 4700s. After upgrading the kitProg firmware (as requested (demanded) by Psoc Creator 4.2) via Psoc Programmer 3.28 I found I was no longer able to build projects on this microprocessor; and i get the above two messages. Anyone have any recommendations.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Gregory,
Could you please tell full version of the PSoC Programmer ? Or update it to the latest using the following link https://www.cypress.com/products/psoc-programming-solutions
You can also install the following files for the kit,https://www.cypress.com/file/474291
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Gregory,
Could you please tell full version of the PSoC Programmer ? Or update it to the latest using the following link https://www.cypress.com/products/psoc-programming-solutions
You can also install the following files for the kit,https://www.cypress.com/file/474291
Best Regards,
Vasanth