10 Replies Latest reply on Jun 19, 2019 5:05 PM by MoTa_728816

    Is it possible to invert Pin for Interrupt?

    thwic_4148901

      Hello,

       

      I'm using PsoC 4 CY8C4127AZI-S445 and I need an interrupt from an digital input pin.

       

      So far so good. Following picture shows how I created it in the TopDesign:

       

      I'm getting an interrupt unfortunately inverted, it means when an interrupt should be triggered there is no interrupt and there is an interrupt when no interrupt should be triggered.

      Changing interrupt setting from pin to falling edge or rising edge doesn't make any difference.

      Is it possible to invert the input pin and then trigger the interrupt? If yes how?

       

      Thanks & best regards.