4 Replies Latest reply on Jun 19, 2019 8:38 AM by DheerajK_81

    problem with MiniProg4 and Psoc Programmer

    userc_4102431

      Hi all,

       

      I am tring to program my caustem board( PSoC 4700) using MiniProg 4 . In datesheet is say you can use either 10-pin or 5-pin conector to program the MCU using SWD protocol but I could not change the connector to 5-pin . The default connector is 10-Pin. How can I change this to 5-Pin ? because I design my board using 5-Pin.

       

      Thank u