CYUSB306X validate the CSI 2 lane interface by SI validation

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
dhpic_4264511
Level 1
Level 1

Hi,

I am implementing the CYUSB3064 IC in my design. I am iterating the SI simulations on this Cypress bridge IC and need to validate its CSI 2 lane interfaces for both the CSI channels.

Please share any references or document for CSI-2 lane eye mask specifications if the CSI signals are referenced to the clock speed range of 250MHz to 950MHz.

Thanks,

Dhara

0 Likes
1 Solution
Keerthy_V
Moderator
Moderator
Moderator
First like given 250 sign-ins 50 solutions authored

Hi Dhara,

CX3 supports MIPI CSi -2 receiver only. It doesn't have a MIPI CSi-2 transmitter. The eye diagram test is conducted for transmitter but not for the receiver.

For MIPI D-PHY electrical characteristics , please refer table 9 of CX3 datasheet. The datasheet link is given below :

https://www.cypress.com/file/133591/download

Regards,

Keerthy

View solution in original post

0 Likes
1 Reply
Keerthy_V
Moderator
Moderator
Moderator
First like given 250 sign-ins 50 solutions authored

Hi Dhara,

CX3 supports MIPI CSi -2 receiver only. It doesn't have a MIPI CSi-2 transmitter. The eye diagram test is conducted for transmitter but not for the receiver.

For MIPI D-PHY electrical characteristics , please refer table 9 of CX3 datasheet. The datasheet link is given below :

https://www.cypress.com/file/133591/download

Regards,

Keerthy

0 Likes