- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I am trying the first project using ModusToolBox IDE on Linux
The project is blinky_LED_main app and I changed LED pin according the schematic.
Compilation is ok but debug does not work:
Open On-Chip Debugger 0.10.0+dev-2.1.0.99 (2019-02-01-13:19)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
adapter speed: 1500 kHz
adapter speed: 1000 kHz
** Auto-acquire enabled, use "set ENABLE_ACQUIRE 0" to disable
cortex_m reset_config sysresetreq
cortex_m reset_config vectreset
adapter_nsrst_delay: 200
Info : CMSIS-DAP: SWD Supported
Info : CMSIS-DAP: JTAG Supported
Info : CMSIS-DAP: FW Version = 1.10
Info : CMSIS-DAP: Serial# = 0721106503068400678901234567890123
Info : CMSIS-DAP: Interface Initialised (SWD)
Info : SWCLK/TCK = 1 SWDIO/TMS = 1 TDI = 0 TDO = 0 nTRST = 0 nRESET = 1
Info : CMSIS-DAP: Interface ready
Error: *******************************************************************************************
Error: * KitProg firmware is out of date, please update to the latest version using fw-loader at *
Error: * ModusToolbox/tools/fw-loader *
Error: *******************************************************************************************
Error: No Valid JTAG Interface Configured.
Where I cant found last version of kitprog? Is kitprog2 or kitprog3 ?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for feedback.After updating to kitprog3 now I can flash and debug.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The error massage report your Kitprog firmware version is out of date, so you should connect your board to laptop, open PSoC Programmer and update the firmware to latest version.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for feedback.After updating to kitprog3 now I can flash and debug.