- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Flash programmer for downloading the *.mhx file into MB95F778 controller. Binary downloads properly and flash verification is also ok .But binary execution does not happen after programming and System doesnot start .But when I program in release mode using softune then it works
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It's possible the HW reset is not issued by Flash programmer after the programming is finished. Is it effective if you make a HW reset on board? or the board never works finely programmed through Flash programmer?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It's possible the HW reset is not issued by Flash programmer after the programming is finished. Is it effective if you make a HW reset on board? or the board never works finely programmed through Flash programmer?