I made that post a few months back. For this case, I need to generate a 60 Hz 50% duty cycle PWM wave, however, I need to have two of them (The original and the inverted one). Both the original and the inverted will have a dead time in between transitions.
It would be helpful to have a timing diagram or chart explaining project specifications.
You can make the following settings to generate two PWM waves that are inverted and have a dead time between them:
The PWM Mode is set to: two modes (in order to generate two waveforms)
The Compare value has been set to half the period value, so that the duty cycle is 50 percent.
The CMP Type value for the two waveforms is set to: less than and greater than or equal two so that the two waveforms are inverted.
The Dead band is used to set the dead time the waveforms between them.