2 Replies Latest reply on Apr 11, 2019 7:21 AM by jahsc_972471

    how to download firmware everytime my application runs

    jahsc_972471

      My requirement is to download firmware to RAM every time my application starts up. I'm using CYUSB3KIT-003 and have my J4 always closed so that I can always get the boot loader running when restart my computer or re-plug-in USB cable. Then my application find the status of the board is programmable then download firmware to RAM and it becomes 'streamerexample' in control center and my application can talks to it successfully.   It works fine in this use case.

       

      The issue is after I close my application, restart it again but now the boot loader is not running.  I can't download the firmware again.  I tried either CCyUSBDevice::Reset() or CCyUSBDevice::ReConnect() works. Please advice !  Very Appreciated !