- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I can see IO-status during power-on-reset on your Datasheet.(Table 11. FX2LP Pin Descriptions[13])
Are these spec same as during power-up (0V to 3.3V) ?
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
(Updated)
The FX2LP IO pins are HIGH-Z on power up.
The FX2LP IO pins are treated as input pins upon power-up.
The input pins cannot be left floating and should either be pulled up or pulled down.
Pull-up or pull-down resistors should be provided externally.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
(Updated)
The FX2LP IO pins are HIGH-Z on power up.
The FX2LP IO pins are treated as input pins upon power-up.
The input pins cannot be left floating and should either be pulled up or pulled down.
Pull-up or pull-down resistors should be provided externally.
Best regards,
Hirotaka Takayama