1 Reply Latest reply on Mar 28, 2019 5:56 AM by BragadeeshV_41

    Issue in UART Commuications

    jamec_2673086

      Hello,

      We are using PSoC63 based CYBELE-416045-02 EZ Ble module for our application. In that, we have an application to send command  & receive its response through UART component.

      But the issue is I am not able to receive the response in Rx buffer of UART.

      I have used UART_Put() & UART_Get() in loop to send full command & receive full response.

      In Response of UART_Get(), I can see there is the same data which was sent before a command, It means we are receiving exactly what we are sending.

      Can I have any solution for this problem/I am missing some steps in UART communication?