2 Replies Latest reply on Mar 18, 2019 3:08 AM by jaemann.park_1817436

    How to initialize debug target settings

    jaemann.park_1817436

      I am using MiniProg3 and PSoC Creator 4.2 to program my custom board.

       

      Everything was working fine until I changed the 'Programming Mode' to 'Power Cycle'. Not only that I cannot acquire the target, the power on the MiniProg3 just keeps toggling on and off. PSoC Creator is unresponsive during this period and the only way to stop this is to unplug the MiniProg3.

       

      I can successfully flash my target using PSoC Programmer in both 'Power Cycle' mode and 'Reset' mode. I have tried reinstalling PSoC Creator but the settings have not been initialized.

       

      Is there a way to initialize the debug target settings?