- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
At this point, I know how to use the tester to force Bluetooth into test mode.But I hava a idea: Can the tester be Bluetooth? If it is possible, how to use another Bluetooth to send LMP PDUs to the DUT to activate test mode?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If the tester is bluetooth device, the command may not be LMP PDU. You need to define the command from the tester to the gateway. Then the gateway can translate your vendor command to HCI command and sent it to the DUT.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There is no such way to do the test and the SIG also doesn't have the SPEC.
If you want to test it through OTA, you may connect the DUT with a host through HCI UART. Then the host(which also has BT capability) connects with another bluetooth device which can send command. But you need to define the command by yourself.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your answer!
But, I am sorry that I didn't understand. Can you elaborate on the second half?
The command that I need to define is HCI command? Do you mean to connect two controllers via two UARTs with one host? or use Bluetooth A connect to Bluetooth B as a master while connecting another Bluetooth C as a slave?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the systme, there are three Bluetooth devices: the tester, DUT and another device(let's call it gateway). The tester send commands to the gateway with BT connection. The gateway connects with DUT through UART. The gateway also receive commands from the tester and translates it to HCI commands.
You should define the commands between tester and gateway. The gateway then sends test commands to the DUT.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your patience, I still have a little problem.
I think the ultimate goal is to have the gateway send the LMP_test_activate PDU to the DUT to activate the test mode and use the LMP_test_control PDU for testing. So I need the gateway to translate the LMP PDU sent from the tester into an HCI command, but the LMP is under the HCI, will the data received by the gateway pass through the UART? How to translate it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If the tester is bluetooth device, the command may not be LMP PDU. You need to define the command from the tester to the gateway. Then the gateway can translate your vendor command to HCI command and sent it to the DUT.