5 Replies Latest reply on May 5, 2019 9:57 PM by alamandaa_16

    CX3 Debugging with JTAG Lauterbach is not possible if SPI is flashed

    user_3245401

      I am using a lauterbach JTAG model LA-3500 DEBUG-USB3 for ARM9 with Denebola board based on CX3.

      When I flash my own bootloader in SPI, It is not possible to debug with JTAG  using the following command:

      D.LOAD D:\Dev\SmileFW\Bootloader_v2\CX3\Bootloader_v2\Release\Bootloader_v2.elf /NOCODE

      On the other hand if the spi is empty (full of 0xff) It is possible to step , put break point .

      I don't figure out why it is not possible to debug with SPI flash loaded ?