I am powering my CYBLE-214009-00 chip through a source selector. I believe when the source selector switches from one voltage source to the next, there is a voltage dip in the output voltage of the source selector (input VDD of my CYBLE chip) and the chip resets.
I want to stop this reset from happening, which is why I'm wondering if I can change the Brown Out Detection voltage somehow.
Open to any other suggestions.
I would recommend to use a cap as a solution for this issue. It is not possible/recommended to change the BOD voltage because it might cause the application corruption ( Flash etc) on operating at a voltage lower than the minimum operating voltage of chip.