- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi. We have custom board with CYW43907 chip. When connecting with J-Link raised next problem. "Could not power up debug port. Control/Status register reads 00000103. Failed to connect". Our design similar to CYW943907 Evaluation Kit.
Any suggestions to resolve this problem? What we do wrong?
Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please check the JTAG HW connection in your custom board and also check this Flash CYW43907 with Segger standard tools (J-Flash, J-Flash Lite, Command Line) to know if you have followed the steps as mentioned here
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please check the JTAG HW connection in your custom board and also check this Flash CYW43907 with Segger standard tools (J-Flash, J-Flash Lite, Command Line) to know if you have followed the steps as mentioned here