- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I wanted to know if there is a way we can set a test mode while in HCI mode. Our test would simply require to Tx on a single BT channel.
Any insight would be useful. Thanks!
Regards,
Jay
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, you can put the device in HCI mode and then send the test command with mbt or cybluetool.
Refer to the following KBA for HCI modePutting 2073x, 2070x, and 20719 Based Devices or Modules in HCI Mode – KBA225450
You can get cybluetool here: CyBluetool User's Guide CyBluetool (Windows Installer)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, you can put the device in HCI mode and then send the test command with mbt or cybluetool.
Refer to the following KBA for HCI modePutting 2073x, 2070x, and 20719 Based Devices or Modules in HCI Mode – KBA225450
You can get cybluetool here: CyBluetool User's Guide CyBluetool (Windows Installer)