- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone!
I need to use PSoC 6 BLE kit as a programmer for PSoC 6 MCU; however, I am wondering if the kit can program the PSoC 6 MCU which has its own 2.2V power supply.
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, the onboard KitProg2 can program any PSoC 4/5/6 devices connected to J11 header. Switch SW6 should be switched to “External Device” position to program devices connected via J11 header. It doesn't matter if the device is externally powered. Kitprog will measure the target voltage and adjust the voltage levels on the programming pins accordingly.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, the onboard KitProg2 can program any PSoC 4/5/6 devices connected to J11 header. Switch SW6 should be switched to “External Device” position to program devices connected via J11 header. It doesn't matter if the device is externally powered. Kitprog will measure the target voltage and adjust the voltage levels on the programming pins accordingly.
Regards,
Dheeraj