I'm reading the ModusToolbox USB Configurator Guide. It says that the USB-project is configured from the Device Configurator.
In my Device Configurator there is no USB option.
Am I missing something?
From the USB guide there should be a checkbox, as seen in screen shot below:
Source: https://www.cypress.com/file/455251/download
Feb 5, 2019 8:18 PM
Please select option "Select Middleware" and then check USB Device option as shown in image below:
Hi,
are you sure the device has USB support? Can you share the selected Part number?
regards,
Achim
Hi Ryan,
Don't know why you last message was deleted, but the chip on CY8CKIT-062-BLE does not have USB support. It is BLE only. The USB connector is just for debugging.
There is the CY8CKIT-062-WIFI-BT and the CY8CPROTO-062-4343W that both supports USB.
kind regards,
Achim
Hi Achim,
The processor of the CY8CKIT-062-BLE is the PSoC 63. And the datasheet for PSoC 63 says the following:
USB Full-Speed Dual Role Host and Device Interface
PSoC 63 incorporates a dual-role USB Host and Device interface. The device can have up to eight endpoints. A 512byte SRAM buffer is provided and DMA is supported.
(This description is identical to the USB section of the PSoC 62 datasheet)
Does this mean the PSoC 63 part supports USB - but it is not implemented on the CY8CKIT-062-BLE dev kit?
Or am I misunderstanding the Datasheet?
Thanks again!
Regards,
Ryan
Mar 29, 2019 2:50 AM
PSoC63 on CY8CKIT-062-BLE doesn't has USB