1 Reply Latest reply on Feb 5, 2019 8:57 PM by GeonaP_26

    Hello

    jachc_2249776

      Hello,

         We are using MB95F636K for product development ,

         I try to build a example test project in Softune IDE, connect to my target board using MB2146-70-E tool

         After build project success , Attempt to starting debug , an error prompt window appears with error message

          " *** F9411S : Cannot continue debugging due to a CR trimming value error

          How can I solve this problem ?

        • 1. Re: Hello
          GeonaP_26

          The CR trimming value preset for the device may be invalid, or the power supply from the user system may be insufficient.

          Please restart the debug system. If the same error occurs, check the power supply of the user system, or replace the devices.