1 Reply Latest reply on Jan 28, 2019 6:00 PM by LinglingG_46

    Bootloadable *.hex and *.elf files missing

    user_266880443

      I am hoping someone can help with this issue

       

      I had rebuilt the design many times over several days as I updated the TopDesign and main.c

      It was working as expected and I could build and down load to the cy8ckit-049-42xx with no issues

      Changes made to the pwm are verifiable on the o-scope

       

      Then

      During a build both *.hex and *.elf files are deleted or gone

      I cannot set the file paths on the dependency page as the files do not exist now

      The path does not exist. per the errors

       

      I have searched the entire drive to see if maybe they were put somewhere else but none found

       

      Getting the following errors

      error 1

      pft.M0086:

      Error in component: Bootloadable. The referenced Bootloader is invalid. Verify the Bootloader dependency is correct in the Bootloadable Component, then build project. Invalid bootloader hex file. Unable to read the hex file (C:\Users\Ron\Desktop\0 - ELECTRONICS\XXXXXXXX\TS_Tester\TS_Tester\My_TS_Tester.cydsn). The path does not exist.

      Error2

      ft.M0086:

      Error in component: Bootloadable. The referenced Bootloader is invalid. Verify the Bootloader dependency is correct in the Bootloadable Component, then build project. Invalid bootloader elf file. Unable to read the elf file (C:\Users\Ron\Desktop\0 - ELECTRONICS\XXXXXXXXXX\TS_Tester\TS_Tester\My_TS_Tester.cydsn). The path does not exist.

      Error3

      fit.M0050:

      The fitter aborted due to errors, please address all errors and rebuild.

       

       

      This happened to me a couple of times in the past

      The only way to get the files back is to delete the TopDesign and start over with a blank TopDesign

      Comment out all the main.c changes made

      Place a new Bootloadable component on the TopDesign Page

       

      What could be suppressing the making of the *.hex and *.elf files?

       

      Using Creator 4.2

       

      Resources used:

      digital clocks 2/4

      interrupts 3/32

      i/o 7/36

      timer counter 3/4

      udb 100%

           macro cells 10/32

           p terms 10/64

           data path 4/4

           status cells 2/4

           control cells 2/4