How do I connect the I2C/USB Bridge to the MiniProg3?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
antrc_3264986
Level 3
Level 3

I am trying to connect the CapSense Tuner to my custom hardware. Step 5: Assign Pins in Pin Editor of the Quick start guide indicates that the "Alternatively, you can use a MiniProg3 debugger/programmer kit as the USB-I2C Bridge.“ How is this done? There is not explanation.

0 Likes
1 Solution
LinglingG_46
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 10 questions asked

You should connect the minprog sck with the device I2C clk. minprog data with device I2C data, I show it in below:

pastedImage_0.png

I mean: which pins you configured as the i2c pins, you need to connect it with the minprog3 in your board.

View solution in original post

1 Reply
LinglingG_46
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 10 questions asked

You should connect the minprog sck with the device I2C clk. minprog data with device I2C data, I show it in below:

pastedImage_0.png

I mean: which pins you configured as the i2c pins, you need to connect it with the minprog3 in your board.