1 Reply Latest reply on Jan 16, 2019 5:29 PM by ShifangZ_26

    EZ-PD Configuration Utility I2C bridge


      I'm trying to program a CCG4 based chip using the EZ-PD Configuration Utility. Which devices are supported as the bridge in this application?


      So far I've only been able to use a CY7C65215 chip to work with the "EZ-PD Configuration Utility". I've tried using several versions of a PSoC from a development board setup as a bridge without success, I've also tried using an Aardvark from TotalPhase without success.