Jan 01, 2019
05:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2019
05:56 AM
I hope to use 2 out endpoints and 2 in endpoints. I plan to use 1 dedicated flag and 1 dedicated partial flag for each out endpoint, 1 dedicated partial flag for each in endpoint. Therefore I need 6 endpoints in total. Is that feasible for FX3?
Solved! Go to Solution.
1 Solution
Jan 01, 2019
06:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2019
06:12 AM
Hello,
As long as FX3 has got enough GPIO pins, DMA flags can be used. The GPIF II designer tool lets you use 6 DMA flags.
Best regards,
Srinath S
3 Replies
Jan 01, 2019
06:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2019
06:12 AM
Hello,
As long as FX3 has got enough GPIO pins, DMA flags can be used. The GPIF II designer tool lets you use 6 DMA flags.
Best regards,
Srinath S
Jan 01, 2019
06:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2019
06:26 AM
Thank you, the question is well answered
Jan 01, 2019
06:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2019
06:28 AM
Could you please look at my another question, thank you.Does bug exist in partial flag of out endpoint of FX3?