- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I have a board with CYUSB3014 on it, and I made the PMODE[2:0] as "F11".
When I connect the board to PC, I can see "Cypress USE bootloader" in USB Control Center. Then I program the device using Program->FX3->RAM, after the programing, the USB Control Center will show "Program succeeded", but I can't find the device in USB Control Center after the programming. The image file is generated using Existing Project (Cypress\EZ-USB FX3 SDK\1.3\firmware\basic_examples\cyfxbulklpautoenum)using EZ USB Suite.
Is there any possible reason and solution for this phenomenon (can't connect to CYUSB3014 after programming the firmware)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know have you done modification to cyfxbulklpdscr.cpp file? This phenomenon would happen usually because the Vender ID is changed and the computer cannot recognize the device.
Regards,
Eddie