3 Replies Latest reply on Dec 19, 2018 11:08 PM by ViC_3886151

    Cannot measure clock signal at slave device


      Hello everybody.


      I'm interfacing a device through SPI with PSoC 5LP. I have connected an external clock for the SPIM (SPI master) component.


      After starting the SPIM using SPIM_Start() function, I cannot get the clock signal at the SCLK pin of the slave device.

      I tried to do the same using internal clock also. But I still cannot get the clock signal at the slave device when measured using oscilloscope.


      I cannot find the solution for this problem. Any help is appreciated. Thanks in advance.


      Thanks and Regards,