- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I'm using the CY3274-HV PLC development Kit, including the PLC and AMUX4_1 user modules. The AMUX4_1 is used to multiplex 4 analog inputs.
The PLC module is using up port 0 - 0,3,5,6 pins to connect to the AC power line connector.
I have a doubt if the AMUX4_1 will read inputs from the remaining free port_0_1, port_0_2, port_0_4, port_0_7 pins, that is 2 even and 2 odd bits of Port 0, when selected.
Could you please help me know if I could use the select defines AMUX4_1_PORT0_1, AMUX4_1_PORT0_2, AMUX4_1_PORT0_4, AMUX4_1_PORT0_7 ?
These select defines are in sets of even and odd. Or is there an alternative?
Regards,
Tejal
Solved! Go to Solution.
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry, I think you'd better use the PSOC1 forum for that. This is the PSOC5 forum, which is basically different from PSOC1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using the PSoc 5.4 designer tool, hence asked a query here. I have raised a thread on PSoc1 forum as well.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content