4 Replies Latest reply on Dec 12, 2018 3:47 PM by akkoc_979791

    I would like to use the UART signal of  CYUSB3KIT-003.

    akkoc_979791

      I would like to connect UART_RX (J1-19) and UART_TX (J1-21) of CYUSB3KIT-003 to another microcomputer.

      However, the above signal is already connected to the USB serial conversion IC (CY7C65215).

      Will be able to use  UART_RX and UART_TX signals by setting the SCB0 configuration of CY7C65215 to Mode5(I2C)

      and Drive Modes of GPIO_8 and GPIO_5 to TRISTATE using Cypress USB-Serial Configuration Utility ?