6 Replies Latest reply on Dec 13, 2018 7:16 PM by ShifangZ_26

    How to read CYPD3175 and program it ?

      Hi Cypress

      I got a CCG3 evk power board and i design a charger of CYPD3175, i try to read and program CYPD3175, but i got some error message like below, how to fix it?

      1544143497868.jpg

      Device Discovery completed.

      PD contract established.

      Error: GET_SILICON_ID VDM failed

      Retrying, ignore the above error message

      Error: GET_SILICON_ID VDM failed

      Retrying, ignore the above error message

      Flash update mode (4b4, 1) entered

      Restarting the target device

      Re-negotiating PD contract after switching target reset

      Flashing device is UFP, initiating DR_SWAP

      DR Swap Successful

      Error: GET_SILICON_ID VDM failed

      Retrying, ignore the above error message

      Flash update mode (4b4, 1) entered

      PD contract established.

      Error: PD contract not established after RESET

      Error: DLL call returned error while reading the configuration