2 Replies Latest reply on Dec 6, 2018 10:48 PM by RoCa_1222471

    PSoC 4 HW digital output is driven by the signal connected to it and hence the initial drive state  parameter should not be used.

    RoCa_1222471

      I'm using PWM_3CMP-v1_00 component (found into community) to control RGB leds but initial drive state of external pin is forced High (1) at power up and is not possible to change it to low voltage. GPIO datasheet says that from version 2.10 "PSoC 4 HW digital output is driven by the signal  connected to it and hence the initial drive state  parameter should not be used."

       

      (I attached the component for RGB leds driver)

       

      How is possible to modify the PWM_3CMP_v1_00 component to avoid leds on at power up? Or there's  another way to solve this issue?

       

      Thank you