3 Replies Latest reply on Dec 4, 2018 10:54 PM by ShipingW_81

    How to use the Bridge Control Panel with PSoC 6

      Hi everyone,

       

      I'm quite new to PSoC and still don't understand how to transfer data all that well. I have a project using the MPU6050 motion sensor.

       

      Right now, I'm trying to transfer the data over to BCP but it's not going smoothly. The BCP either refused to run or the result goes to 0. It's probably not a problem with my source code, since it runs well in TeraTerm (I don't know if it's a problem with the UART source code though). I used this code as a reference for the BCP transfer code.

       

      Thanks in advance,

      Dhiya