2 Replies Latest reply on Dec 1, 2018 9:28 AM by bojec_3707286

    UART i2C both use problem


      Hello Friends


      i'm trying to use i2c sensor and want to show the sensor value in Serial Monitor in PC


      So i try 2 SCB ( UART and I2C)  like the screenshot


      and wrote code like this


      #include "project.h"
      //#define I2C_SLAVE_ADDR      (0x28u)
      int main(void)
          CyGlobalIntEnable; /* Enable global interrupts. */
              UART_PC_UartPutString(" PM2008 TEST \r\t" );


      when i did not use i2c block , the monitor gives me correct message for each 1 seconds,


      but i use i2c block monitor goes like this



      it gives me a lots of message, i think something is wrong,,


      does somebody have same experience like me ?