1 of 1 people found this helpful
The initial Tx power will depends on which you have set and programmed to the chip. The Tx parameter can be set in the application run time.
By default CYBT-343026-01 is shipped with Ez-serial FW . And the default Tx power set in that is 0dB (http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform)
RF test reports and Certificates of CYBT-343026-01 is available here: https://community.cypress.com/docs/DOC-14196
Thanks & Regards,