Attachments are accessible only for community members.
Anonymous
Not applicable
Nov 24, 2018
06:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 24, 2018
06:47 PM
hello, here I attached my project, im using mpu6050 sensor to run 2 motors. I should control the speed and the direction of the motors but Im struggling with writing the loop and getting the values for the gyroscope and the acceleration. I really need helps with that so please check the file that I attached. Thank you.
2 Replies
Nov 25, 2018
05:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2018
05:17 AM
I cannot open your file. Please use Creator->File->Create Workspace Bundle (minimal) and attach the resulting .zip file.
Bob
Nov 29, 2018
12:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 29, 2018
12:12 AM
Discussion moved to another thread you created: MPU6050 Need help for the direction and speed
Regards,
Dheeraj