- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could you tell me that if the initial state including S/W is exactly the same about CYBT - 343026 - 01 below two cases?
1, To be implemented on the evaluation board
2, To be purchased as a reel item
For example, I think that the port setting of PUART of the evaluation board mounted product is as shown in the circuit diagram of the evaluation board.
I would like to check if the reel product setting that it is a difference such as data sheet.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
CYBT-343026-01 is preprogrammed with EZ-serial FW (http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform) before coming to market. So in any case the PUART port settings will be the same.
However in production time the initial state or settings depends on the application firmware you are going to program into the chip and platform file settings. (Platform Files for CYBT-343026-EVAL – KBA221025 ).
Thanks,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
CYBT-343026-01 is preprogrammed with EZ-serial FW (http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform) before coming to market. So in any case the PUART port settings will be the same.
However in production time the initial state or settings depends on the application firmware you are going to program into the chip and platform file settings. (Platform Files for CYBT-343026-EVAL – KBA221025 ).
Thanks,
Anjana