Nov 07, 2018
07:09 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 07, 2018
07:09 PM
Hi,
Miniprog3 can only be used as programmer, can't be changed to I2C communication mode.
How to repair it? Thanks.
4 Replies
Nov 07, 2018
10:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 07, 2018
10:16 PM
Are you using the 5 pin connector of the Miniprog3 to do I2C communication?
What do you see in the Bridge Control panel(assuming you are using this for I2C) GUI? Not in the available port list?
Roy Liu
Nov 07, 2018
11:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 07, 2018
11:13 PM
Yes, 5 pin connector.
Failed to enumerate I2C devices when click "List" button.
Nov 07, 2018
11:18 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 07, 2018
11:18 PM
Mostly not an issue with the Miniprog3, but the PSoC that MiniProg3 connecting with, did you try with other PSoC boards/EVK?
Roy Liu
Nov 07, 2018
11:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 07, 2018
11:22 PM
This Miniprog3 could program each PSoC normally.
If possible, I can provide this Miniprog3 to your side for testing.