- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
As title states, my miniprog3 isn't working with the PSoC 6 module I got my hands on recently. I receive the it's "recognized but not supported" message.
If this is a software update issue, when do you expect to have the compatible PSoC creator released?
Thank you
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This could be more than a hardware issue if you are using the latest Creator/Programmer, check out Prerequisite Software Setup for Getting Started with CYBLE-416045-02 EZ-BLE Module in PSoC Creator –...
And a similar discussion - Miniprog3 not supporting CYBLE-022001?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This could be more than a hardware issue if you are using the latest Creator/Programmer, check out Prerequisite Software Setup for Getting Started with CYBLE-416045-02 EZ-BLE Module in PSoC Creator –...
And a similar discussion - Miniprog3 not supporting CYBLE-022001?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This was the solution. Thank you!