1 Reply Latest reply on Nov 6, 2018 6:50 PM by srnt

    SPI ROM Programming for FX3

    user_245806886

      Hello,

       

      Is it possible to program SPI ROM for FX3 firmware without using Control Center? 

      If don't have any solution from cypress, how about any third party product? 

       

      Thanks

        • 1. Re: SPI ROM Programming for FX3
          srnt

          Hello,

           

          The SPI slave that is used should match the following write commands for successful programming from the USB Control Center.

          • Write Enable: 06h
          • Write data (Page Program): 02h
          • Sector Erase: D8h

           

          In case the commands are different, the USB Control Center can be modified to suit the slave device that is used. The source of the control center can be found from the below path after the installation of FX3 SDK.

          C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\application\c_sharp\controlcenter

           

          Best regards,

          Srinath S