- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
fx2lp is interfaced with image sensor in slavefifo .is there any firmware control with the slavefifo interface signals.
i wanted to stop and start the slwr assertion and deassertion
or
i wanted to stop and start data written to the endpoint buffer from the sensor?
is ther any register settings or any logic can implement?
regards,
geetha.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Geetha,
Since you have mentioned that you are using FX2LP in slave FIFO mode, it acts as the slave and the image sensor acts as the master. So, the FX2LP cannot control the SLWR pin signals from the firmware. They are to be controlled from the external master.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Geetha,
Since you have mentioned that you are using FX2LP in slave FIFO mode, it acts as the slave and the image sensor acts as the master. So, the FX2LP cannot control the SLWR pin signals from the firmware. They are to be controlled from the external master.
Best regards,
Srinath S