- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We are using CCG2 controller to negotiate the voltage over
USB3.1 power line from 5V to either 5/12/15/20V. In existing design I2C
interface of CCG2 controller is connected to FX3 controller (CYUSB3035-BZXC).
The USB data lines from USB type-C connector are connected
to FX3 controller are connected through external Mux/Demux switch.
At the time of design, we took reference from the attached
reference explorer kit and used the same Mux/Demux switch as used in this
reference kit.
Please let us know if we can replaced CCG2 controller and
existing external Mux/Demux with CCG4 PD controller (http://www.cypress.com/products/ez-pd-ccg4m-two-port-usb-type-c-controller-pd-and-high-speed-mux)
and connect with FX3 controller (CYUSB3035-BZXC).
Also, please let us know if there is any explorer kit or
reference design available for the CCG4 controller?
Thanks & Regards,
Sunny Watts
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sunny,
Please follow up on an earlier thread created on the same topic by you - Regarding FX3 Controller and CCG4M PD Controller
Locking this thread so that we can concentrate on one.
Regards,
Rajath
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sunny,
Please follow up on an earlier thread created on the same topic by you - Regarding FX3 Controller and CCG4M PD Controller
Locking this thread so that we can concentrate on one.
Regards,
Rajath