- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a problem about writing to bcm20737s.
I don't know the reason why, but frequently mistake writing to bcm20737s on my original pcb using UART.
Is there any special condition if I want to write always correctly(for example: writing cable must be shorter than 3cm...?)
If you know any document about this problem, please show me...
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Below is a comprehensive blog on programming. Read from section 5.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does programming always fail?
Please check what happened by download.log, etc.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear sir.
Sorry for late reply.
This is still an issue.
We wrote amount of bcm20737s (about 2500pcs) and failed about 20pcs.
Then we never write failed bcm20737s even using recovering.
Are there authentic writing sequence?
If it exists, we need to know.
thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Below is a comprehensive blog on programming. Read from section 5.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
boont
Thank you for answering!
I'll read it!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content