I downloaded Audio Gateway software to the board,and recovered the board.
After that,I press the reset button of the board.
I can also see the trace log that I maked before which the software is I downloaded to the board.
To be clear, when you recover the board, the board will enter the auto-baud mode, which means the device will think that the flash is corrupted. Whether as when you reset the device after recovery, the device will come out of auto-baud mode, whatever is there in flash will be read and therefore you see the logs of the previous software because you have not overwritten it by programming again.
So exact answer of your question can be, the program does not get deleted but recovery gives you the permission to overwrite it with your new program.
Thank you for your answer.
>the program does not get deleted
Recover does not delete the software that downloaded to CYBT-343026-EVAL
>BD address of the paired device will also be deleted.
Please let check it again,Is it correct?
Yes this is correct.!
Could you tell me that Which memory is deleted after recover ?
Serial Flash memor,or RAM memory,ROM memory?
When you program the board, application will be loaded into flash, then gets copied to RAM and from there it executes.
After you do recovery and press reset, the code will again execute from the RAM. So ideally, nothing gets deleted.
Rom is untouched here.
Sorry,I am confused.
>>BD address of the paired device will also be deleted.
>Yes this is correct.!
and the new answer is >nothing gets deleted.
Will BD adrress remain or not after recover.